Filter
Top Products
User instructions
CHANGING A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see “
I
NTERRUPTION A PROGRAM
”);
• select the new program;
• start the program (see “
S
TARTING THE PROGRAM
”).
ANNULLING A PROGRAM
To annul the program, keep the
START/PAUSE
button
(2)
pressed until
the program is interrupted (light on and confirmation beep).
Press button
(2)
again and keep it
pressed until the
lights 4
and
5
(marked
"end") come on.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “
S
TARTING THE PROGRAM
”. The program will resume from the
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
HALF LOAD WASH SETTING (certain models only)
(available in all programs except the soak program)
This function is ideal for small loads and saves
water and electricity. It is controlled by the
HALF
LOAD
button
(5)
and allows washing in the upper
basket only.
IMPORTANT:
at the end of the program remember
to deactivate the function
to ensure the next
wash is not also carried out in half load mode
by
mistake
.