Filter
Top Products
User instructions
33
CHANGING THE PROGRAM
To change the program in progress the dishwasher must be switched off by pressing the
ON/OFF
key
(3)
(see section "3. Description of the controls").
Turn the program selector to the program required and then switch the dishwasher on again by
pressing
ON/OFF
key
(3)
. The dishwasher will carry out the new program automatically.
PROGRAM DELAY
The start of the washing program can be delayed by
from 1 to 9
or
from
1 to 12 hours
, depending
on model. This allows you to operate the dishwasher at the time of day most convenient to you.
Models with delay up to 9 hours:
after carrying out the operations described in the "
SETTING THE WASHING PROGRAM
" section
you have about 1 minute to set the “delay” you require, by pressing the button
DELAYED START
(12)
(see section "3. Description of the controls").
The hours left before the start of the program will be shown on the
DISPLAY
(13)
.
Models with delay up to 12 hours:
using the
DELAYED START
switch
(10)
(see section "3. Description of the controls") set the
“delay” required by setting the pointer against the number indicating the hours. Then carry out the
usual program setting procedures.
CAUTION: always turn the switch clockwise.
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
•
Always try to run the dishwasher
fully loaded
.
•
Do not wash the dishes in running water.
•
Use the washing program that is
most appropriate
for each type of load.
•
Do not carry out any preliminary rinsing.
•
If available, connect the dishwasher to a hot water supply up to 60°C.
•
When possible,
disable the drying cycle
and leave the door open at the end of the washing
cycle: the residual air and heat will dry the dishes perfectly.
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the environment. To avoid
using excessive amounts of detergent and to save on electricity, observe the following:
•
separate
the more delicate items from dishes that are more resistant to aggressive detergents
and high temperatures;
•
do not pour
the detergent directly on the dishes.
If it is necessary to open dishwasher door during the washing cycle, there will be a
1-minute delay
before the program can be resumed. After correctly closing the door, the washing program will start
again from where it was interrupted.
This operation may negatively affective the progress of the washing cycle.
END OF CYCLE
At the end of the washing program the selector will be on one of the
STOP
markers, depending on
the program carried out. Switch off the dishwasher by pressing the
ON/OFF
key
(3)
(see section
"3. Description of the controls").
REMOVING THE DISHES
At the end of the washing program, wait at least
20 minutes
before removing the dishes, to allow
them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in
the lower basket, it is
advisable
to unload the lower basket first, and then the upper basket.