Filter
Top Products
Instructions for the user
30
7. Using the hob
Check that the flame cap crowns, the burner caps and grids
are correctly assembled.
Pins A of the flame cap crowns must be inserted in housings
B of the burner rings, and pins C on the grids must be
blocked in their respective housings on the hob.
7.1 Burner lighting with safety device
Each knob shows the burner it is for (the example at the side corresponds to the front
left burner).
The appliance is equipped with an electronic lighter. Just press and simultaneously
turn the knob anticlockwise to the minimum flame symbol until the burner lights.
Keep the knob pressed down for about 2 seconds to keep the flame alight and
activate the safety device. It may happen that the burner goes out when the knob is
released. In this case, repeat the operation, keeping the knob pressed down for a
longer time.
If the burners should go out accidentally, after a roughly 20 second interval the safety
device intervenes to block gas flow, including when the tap is open.
7.2 Practical advice for using the burners
For better burner performance and minimum gas consumption, flat
bottomed, even recipients must be used, with covers and
proportional in size to the burners (see paragraph “7.3 Diameter of
containers ”).
To avoid overcooking or damage to the surface top while cooking, all
recipients or griddles must be positioned within the cooking hob
perimeter and must be a minimum distance of 3-4 cm from the
knobs.
7.3 Diameter of containers
BURNERS
1 Auxiliary
2 Semi rapid
3 Medium rapid
4 Large rapid
5 UR
Ø min. and max. (in cm)
7-18
10-24
18-24
20-24
20-28