Filter
Top Products
Instructions for the installer
6
2. INSTALLATION OF THE APPLIANCE
The following operation requires building and/or carpentry work so must
be carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry,
metal, solid wood or plastic laminated wood as long as they are heat
resistant (T 90°C).
2.1 Fixing the conventional built-in model to the structure
Create an opening with the dimensions
shown in the figure in the work surface,
observing a minimum distance of 50 mm
from the rear edge.
This appliance can be installed next to walls
that are higher than the work surface, as
long as the distance "X" is kept between the
appliance and the wall, as shown in the
figure, to avoid damage from overheating.
Make sure there is a minimum of 750
mm between the gas rings and any shelf
1)
that may be installed directly above them. Carefully position the gasket provided all
around the outer edge of the hole in the work surface as shown in figure 2, pressing it
down lightly to ensure it adheres properly. The front and rear sides of the gasket must
skim the hole. Now place the hob on the insulating gasket and use the screws and
fixing brackets (fig. 4) to secure the hob to the supporting structure, adjusting it until
perfectly horizontal.
Carefully trim off the excess edge of the gasket C (Fig.3). The dimensions in figure 2
below refer to the distance between the hole and the inside edge of the gasket. Do
not fit the brackets shown in fig. 4 until the hob has been set in place.
2)
3)
4)