Filter
Top Products
Instructions for the Installer
13
5. CHECKING OPERATION
After having fastened the top to the support structure, some simple procedures are required in order to
check that it works properly.
1)
Check for any gas leaks near the cooktop connector, the pressure regulator and the safety valve.
WARNING
FIRE HAZARD
- Use a soapy solution to check for proper tightness.
- Never test for gas leaks with a match or other flames.
- Failure to follow this instruction can result in death or fire.
NOTE: The regulator is fitted with a checkpoint outlet gas pressure to check the exact pressure supplied
to the appliance.
2)
The cooktop's electrical circuit can be checked for proper operation
only after assembly has been completed and you have checked to
ensure that all parts have been fitted properly:
1 a spark must ignite on all burners when the knobs on the top
are pressed
2 when each knob on the cooktop is pressed and turned to the
low flame symbol ( ), the entire crown should light.
3 lf burners do not light properly, turn the control knob to the
"OFF" position O. Check that burner caps and crowns are in the
proper position. Check that the power supply cord is plugged in
and that the circuit breaker or house fuse has not blown. Check
that the shut-off valve is in the "ON" position. Check operation
again. lf a burner does not light at this point, contact your dealer
for assistance.