Smeg SA682X Dishwasher User Manual


 
User instructions
43
CLEANING THE FILTER UNIT
It is advisable to periodically inspect the centre filter
C
and, if necessary, to clean it. To remove
the filter, grip the tabs, turn them anticlockwise and lift upwards;
push the centre filter
D
from the underside to remove it from the micro-filter:
separate the two parts which make up the plastic filter by pressing the body of the filter in the
zone shown by the arrows;
remove the centre filter by lifting it upwards.
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE:
The filters should be cleaned
under running water
using a stiff brush.
It is essential to
thoroughly clean the filters
according to the above instructions: the
dishwasher cannot function if the filters are clogged.
Carefully replace
the filters in their seats, to avoid damaging the wash pump.
PROLONGED DISUSE:
Run the soak program twice in succession.
Unplug
the power cord from the socket.
Leave the door slightly open
, in order to prevent the formation of unpleasant odours inside
the washing tank.
Fill the rinse aid dispenser
.
Shut off the water supply tap.
BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:
Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the
water to run from the water supply tap for a few minutes.
Plug the power cord
back into the socket.
Reconnect the water intake hose and open the tap again.