Filter
Top Products
Instructions for the User
27
9. SPECIAL MAINTENANCE
The oven may require special maintenance or replacement of parts subject to wear such as gaskets,
bulbs, etc. The following instructions describe how to perform these minor maintenance operations.
WARNING
ELECTRICAL SHOCK HAZARD
Before any maintenance operation, disconnect the power supply to the
appliance.
9.1 Replacing the oven light
Remove upper oven
protection A and ring B as
well as the glass
cover C, unscrewing it
anticlockwise. Replace
light bulb D.
Reassemble ring B, cover
C and upper protection A.
CAUTION: The standard bulbs are halogen: do not touch them directly with your fingers. Use
insulation to protect your hand. Use only bulbs that are available at authorized service centers.
NOTE: Use only oven-rated appliance bulbs (T 540°F - 300°C)
9.2 Removing the oven door
9.2.1 Doors with moveable hinge levers
With the oven door completely open, raise the hinge
levers A until they touch the hinge arms B, then grasp
both sides of the door near the hinges. Raise the door
to an angle of about 45° and remove it. If the hinge
arms do not lock, repeat the operation, raising the
hinge levers and keeping the oven door slightly raised.
To remount the door, fit the hinges arm B into the hinge
slots, then lower the door into place, making sure that
the hinge arm notch C, is firmly seated in the slot, then
lower the hinge levers A.