Filter
Top Products
Instructions for the installer
17
13.INSTALLATION OF THE APPLIANCE
It is the law that all gas appliances are installed by competent persons. This appliance may be installed
next to a wall which is higher than the appliance, as shown in the diagram showing the correct
installation conditions. Any wall cupboards or shelves must be at a distance of at least 750 mm above
the work surface.
13.1 Electrical connection
Check that the voltage and dimensioning of the supply line correspond to the characteristics shown on
the plate fixed to the rear protective cover of the appliance.
This plate must never be removed.
If the appliance is connected to the supply by means of a fixed connection, install a multipolar cut-out
device on the line, with contact opening distance equal to or greater than 3 mm, located near the
appliance and in an easily reachable position.
The connection terminals are located at the rear of the
appliance. For electrical connections see following diagram. To
access, remove the rear cover.
For operation on 380-415V3N
˜
: use an H05RR-F / H05RN-F /
H05V2V2-F type five-core cable (5 x 2.5 mm
2
).
For operation on 380-415V2N
˜
: use an H05RR-F / H05RN-F/
H05V2V2-F type five-core cable (cavo di 4 x 4 mm
2
).
For operation on 220-240V
˜
: use an H05RR-F / H05RN-F /
H05V2V2-F (cavo di 3 x 6 mm
2
).
The cable end to be connected to the appliance must be provided
with an ground wire (yellow-green) at least 20 mm longer.