Filter
Top Products
4
WIRING (REFER TO FIGURE 3)
IMPORTANT: The power must be disconnected before installation is complete.
IMPORTANT: Be certain all wiring complies with local safety codes and standards and that
the unit is properly grounded.
1. Run the power leads from the wall switch, time switch, or speed control switch to the unit.
2. Using approved wire connectors, connect the supply wires to the fan wires: black (or
brown) to black (or brown) and white (or blue) to white (or blue). Connect the ground wire
(green or bare copper) to the ground connection on the fan junction box.
1. Remove the louver (fan grate) from the unit before
mounting.
2. Separate the air exhaust adaptor from the housing
3. Mount the air exhaust adapter to the wooden frame and
secure using screws (as show in Figure 2).
4. Insert the housing to fit into the air exhaust adaptor and
wooden frame. Secure the housing to the wooden frame
using screws. To avoid vibration, place rubber washers
between the housing and the wooden frame. Secure the
housing to the air exhaust adaptor using the provided
screws.
5. The flange of the housing must be leveled for the louver
to fit properly.
6. Hang the unit to the roof using hangers when necessary.
7. Both installations seen in figure 2 can be used at the
same time.