Filter
Top Products
MQ STOW MS30H/MS30E MIXER — PARTS & OPERATION MANUAL — REV. #4 (08/10/06) — PAGE 23
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
NEVER operate the mixer
in a confined area or
enclosed area structure
that does not provide ample
free flow of air
.
ALWAYS wear approved eye and hearing
protection before operating the mixer.
NEVER place hands or feet inside the guard
cover while the engine is running. ALWAYS
shut the engine down before performing any
kind of maintenance service on the trowel.
MS30H/MS30E MIXER — PRE-INSPECTION
It is recommended that the mixer's
kill switch
be used to stop
the engine after every use. Doing this will verify that the switch is
working properly and presents no danger to the operator.
Before Starting
1. Read safety instructions at the beginning of manual.
2. Clean the
mixer
, removing dirt and dust, particularly the
engine cooling air inlet, carburetor and air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty, replace
air filter with a new one as required.
4. Check carburetor for external dirt and dust. Clean with dry
compressed air.
5. Check fastening nuts and bolts for tightness.
Engine Oil Check
1. To check the engine oil level, place the trowel on secure level
ground with the engine stopped.
2. Remove the filler dipstick from the engine oil filler hole
(Figure 10) and wipe it clean.
Figure 10. Engine Oil Dipstick (Removal)
3. Insert and remove the dipstick without screwing it into the filler
neck. Check the oil level shown on the dipstick.
4. If the oil level is low (Figure 11), fill to the edge of the oil filler
hole with the recommended oil type (Table 7). Maximum oil
capacity is 400 cc.
NOTE
Reference manufacturer engine
manual for specific servicing
instructions.
Figure 11. Engine Oil Dipstick (Oil Level)
epyTliO.7elbaT
nosaeS erutarepmeT epyTliO
remmuS rehgiHroC°52 03-W01EAS
llaF/gnirpS C°01~C°52 02/03-W01EAS
retniW rewoLroC°0 01-W01EAS