Filter
Top Products
LEVELING:
Unit must be level to assure maximum performance. Improper leveling may void warranty.
TO INSTALL RANGE:
1. Inspect for shipping damage as outlined in front of manual (page 1).
2. Cut banding straps and remove corrugated box from range.
3. Cut banding strap, holding range to wooden skid.
4. Locate box marked “legs” or “casters.”
A gas pressure regulator is supplied and already installed on the incoming gas line.
If legs or casters are not received, contact your Southbend Sales Representative.
Please have your model and serial number ready when you call.
LEGS OR OPTIONAL CASTERS:
1. A set of legs or casters are packed in the unit. A threaded receptacle is fastened to the base frame at each
corner. Each leg or caster has a similar mating thread. Install casters with locking brake to the front of unit.
2. Raise unit sufficiently to allow legs or casters to be screwed into the receptacles. For safety, “shore up” and
support the unit with an adequate blocking arrangement (strong enough to support the load.)
3. Lower unit gently. Never drop or allow the unit to fall.
4. The legs or casters can be adjusted to overcome a slightly uneven floor.
5. After the unit has been leveled, tighten the lock nuts. (Lock nuts supplied with casters only.)
6. Casters are provided with a Zerk fitting for proper lubrication when required.
FIGURE
3
ITEM
PART NUMBER
DESCRIPTION
A
1146201
l/4 x 20
x 3/4 Hex Head
B 1146500
l/4 Lock Washer
C
1172650
Leg Pad (3/4 x 10 hole)
*
1174263 5” Swivel Caster Less Brake
D
1174264
5” Swivel Caster with Brake
*
1174265 Caster Package
*1174265 Caster package consists of two 1174265 and two 1174263.
Bolts, lock washers, and leg pads are not
included in caster package.
PAGE 9