Southbend HDG-36 Griddle User Manual


 
HEAVY DUTY COUNTERLINE OPERATION
OWNERS MANUAL 1182845 REV 8PAGE 23
OPERATION
OPERATION OF MANUAL GRIDDLE MODELS
Each 12"-wide griddle section has a knob on the front panel that directly controls the flow of gas, and so the
heat. Turn the knob clockwise to increase the heat; turn it counterclockwise to reduce the heat.
After each period of use, allow the griddle surface to cool normally. At the end of each day’s use, turn all
control knobs to the “OFF” position. After the griddle has cooled, coat the griddle surface with a light film of
cooking oil to protect the surface from moisture.
To shut down the appliance for an extended period (or before disconnecting the gas supply), turn all the
burner control gas knobs “OFF,” then turn the main gas supply valve(s) to “OFF.”
To light the pilots of a manual griddle section, do the following:
1. Turn all griddle controls to the “OFF” position.
2. Light the pilot tube located next to each burner. The pilot flame can be adjusted by turning the screw on
the end of the pilot fitting.
3. Turn burner knobs to “HI” position. The burners should have a 1/2" to 5/8" steady blue flame. Adjust if
necessary.
4. To turn burners off, turn knob to “OFF” position.
Figure 15
Left Pilot
Right Pilot
(36" & 48" Models)
The drawing below shows a Model HDG-36-M with the front panels removed to show the interior parts.
Note: 24" models have one pilot, 36" and 48" models have two pilots, 60" models have three pilots, and 72" models have four pilots.
The pilots can be viewed and lit through openings on the
front panel (Model HDG-36-M shown).