Filter
Top Products
OPERATION HEAVY DUTY COUNTERLINE
PAGE 22 OWNER’S MANUAL 1182845 REV 8
OPERATION
OPERATION OF THERMOSTATIC GRIDDLE MODELS
Each 12"-wide griddle section has a thermostatic-control knob on the front panel that directly controls the
flow of gas, and so the heat. Turn the knob clockwise to increase the heat; turn it counterclockwise to
reduce the heat.
The griddle requires approximately 13 minutes of preheating to reach 350°F, and 45 minutes to even out.
Do not waste gas or abuse equipment by leaving control knobs set at a high temperature if not required.
During idle periods, set control knobs to low temperature settings to keep griddle warm.
After each period of use, allow the griddle surface to cool normally. At the end of each day’s use, turn all
control knobs to the “OFF” position. After the griddle has cooled, coat the griddle surface with a light film of
cooking oil to protect the surface from moisture.
To shut down the appliance for an extended period (or before disconnecting the gas supply), turn all the
burner control gas knobs “OFF,” then turn the main gas supply valve(s) to “OFF.”
To light the pilots of a thermostatic griddle section, do the following:
1. Turn all griddle controls to the “OFF” position.
2. Open the grease/control door at the bottom of the front of the griddle.
3. Turn the main shut-off valve to the “ON” position (if it is not already ON). (Note that 60" and 72" models
have two shut-off values, one in each burner compartment.)
4. Note that the left pilot must be lit before the right pilot can be lit. For each pilot, press and hold the
red pilot button and light the pilot by pressing the electronic ignition button on the front panel to
generate a spark. Continue to hold the pilot button for 45 seconds, or until the pilot remains lit. Note
that 24" models have one pilot, 36" & 48" models have two pilots, 60" models have three pilots, and 72"
models have four pilots.
5. If a pilot is extinguished or the gas supply is interrupted, wait five minutes and repeat the above steps.
6. Allow the pilots to warm-up for 1 minute, then turn all griddle thermostat controls to the “ON” position to
check that the pilots will ignite the burners.
Figure 14
Left Pilot
Button
Right Pilot Button
(36" & 48" Models)
Left Pilot
Right Pilot
(36" & 48" Models)
This drawing shows a Model HDG-36 with the front panels removed to show the interior parts.
Note: 24" models have one pilot, 36" and 48" models have two pilots, 60" models have three pilots, and 72" models have four pilots.
60" and 72" models have two shut-off valves, one in each burner compartment .
Grease Drawer
Main Shut-Off
Valve