Southbend SLGB/15CCH Oven User Manual


 
I
NSTALLATION
M
ARATHONER
G
OLD
& S
ILVER
S
TAR
G
AS
C
ONVECTION
O
VENS
P
AGE
18 O
PERATOR
S
M
ANUAL
1181887
REV
1
INSTALLATION
Step 5: Install Down Draft Diverter (if applicable)
NOTICE
Installation must use approved CSA International down draft diverter supplied by Southbend.
If the oven flue is to be connected directly to an external vent, a down draft diverter must be installed. The
installation of ventilation pipes through walls and roofs must conform to all local codes. To install the down
draft diverter, do the following:
1. Slip the down draft diverter over the top of the flue located at the top left rear corner of the oven (see
drawing below). Allow the diverter to slide down as far as it will go.
2. Using a 9/64" or 5/32" drill bit, drill eight holes through the flue box using the pre-drilled holes in the
diverter as a guide.
3. Secure the diverter to the flue box using the #10 x 1/2 sheet metal screws shipped with the diverter.
Installation of Down Draft Diverter