Southbend SLGB/22SC Oven User Manual


 
T
ROUBLESHOOTING
M
ARATHONER
G
OLD
& S
ILVER
S
TAR
G
AS
C
ONVECTION
O
VENS
P
AGE
42 O
PERATOR
S
M
ANUAL
1181887
REV
1
TROUBLESHOOTING
T
ROUBLESHOOTING
!
WARNING
ADJUSTMENTS AND SERVICE WORK MAY BE PERFORMED ONLY BY A QUALIFIED
TECHNICIAN WHO IS EXPERIENCED IN, AND KNOWLEDGEABLE WITH, THE OPERATION OF
COMMERCIAL COOKING EQUIPMENT. HOWEVER, TO ASSURE YOUR CONFIDENCE,
CONTACT YOUR AUTHORIZED SERVICE AGENCY FOR RELIABLE SERVICE, DEPENDABLE
ADVICE OR OTHER ASSISTANCE, AND FOR GENUINE FACTORY PARTS.
NOTICE
Warranty will be void and the manufacturer is relieved of all liability if service work is performed by
other than a qualified technician, or if other than genuine Southbend replacement parts are installed.
In case of problems in operation at initial installation, check type of gas and manifold pressure and
compare with information listed on the serial plate. The serial plate is located inside the lower front panel.
PERFORMANCE STANDARD
The typical time for the oven to heat from 75°F to 350°F is 5 to 6 minutes for ovens using natural gas, and
7 to 8 minutes for ovens using propane.
The burners should come on when the actual oven temperature drops to 10°F below the temperature
setting.
INTERPRETING DISPLAYED ERROR CODES
Programmable and Rack Timer models are able to detect some problems that might occur. If the control
panel display is showing a letter “F” followed by a number, consult the following table to determine the
problem and appropriate corrective action.
Symptom Possible Cause Check or Replace
Display shows F1 Bad temperature controller. Replace temperature controller.
Display shows F2 Oven interior maximum temperature
exceeded.
Check whether gas valve is stuck open. If not, replace temperature
controller.
Display shows F3 Open temperature probe. Check connection. If connection is OK, replace probe.
Display shows F4 Shorted temperature probe. Check probe wires. If wires are not shorted, replace probe.
Display shows F5 Bad temperature controller. Replace temperature controller.
Display shows F6 Bad temperature controller. Replace temperature controller.
Display shows F7
Total cook time in a program exceeds 24
hours (programmable models only).
Change program so that total cook time does not exceed 24 hours.
Display shows F8 Bad temperature controller. Replace temperature controller.