Filter
Top Products
Powder Hopper Loaders Page 15
• If your blender has been inoperative or unattended, check all
settings before starting the unit.
• At the beginning of your shift and after breaks, verify that the
controls and other auxiliary equipment are functioning
properly.
• Keep all safety guards in place and in good repair. NEVER
attempt to bypass, modify, or remove safety guards. Such
alteration is not only unsafe, but will void the warranty on your
equipment.
• When changing control settings to perform a different mode of
operation, be sure selector switches are correctly positioned.
Locking selector switches should only be adjusted by
authorized personnel and the keys removed after setting.
• Report the following occurrences IMMEDIATELY:
• unsafe operation or condition
• unusual blender action
• leakage
• improper maintenance
• NEVER stand or sit where you could slip or stumble into the
loader while working on it.
• DO NOT wear loose clothing or jewelry, which can be caught
while working on a loader. Also cover or tie back long hair.
• Clean the loader and surrounding area DAILY, and inspect the
machine for loose, missing or broken parts.
• Shut off power to the loader when it is not in use. Turn the
switch to the OFF position, or unplug it from the power
source.
2-7 Maintenance Responsibility
Safety is essential to the good health of both operator and machine.
If you are a maintenance worker, you must make safety a priority
in order to effectively repair and maintain equipment.
BEFORE REMOVING, ADJUSTING, OR REPLACING
PARTS ON A MACHINE, REMEMBER TO DO THE
FOLLOWING: