Filter
Top Products
Page 24 Powder Hopper Loaders
4 Installation & Setup
4-1 Safety Considerations
; Connect the hopper loader to a grounded three-prong power
receptacle. If this is not possible, ground the hopper loader
motor for electrical isolation and protection from electric
shock.
; Do not use hopper loaders in explosive atmospheres.
; Do not use outdoors or in wet environments. Moisture damages
the motor and can create an electric shock hazard.
; Operate hopper loaders at the rated voltage. Operation at other
than design voltage can result in, at best, poor performance,
and can cause damage to the vacuum motor, control, and
personnel.
4-2 Necessary Tools
; Hand drill
; Pop-rivet gun
;
3
/16” (about 4.8 mm) -diameter rivets
4-3 Mounting Powder Hopper Loaders
Important! You can mount your powder hopper loader directly to the
processing machine by cutting a hole in the machine bin lid
and fastening the hopper loader to it. The hopper loader
mounting flange mates with ACS equipment and uses the
same mounting holes as previous ACS models.
For new installations or mounting on other manufacturer’s
equipment, a hole location template is included in the information
packet.