Filter
Top Products
7
SECTION 3
INITIAL SETUP AND OPERATION
3.1 OPERATOR'S SAFETY PRECAUTIONS
SAFE OPERATION IS NO ACCIDENT; Observe these
rules:
A. Know the freezer. Read and understand the
Operating Instructions.
B. Notice all warning labels on the freezer.
C. Wear proper clothing. Avoid loose fitting gar-
ments, and remove watches, rings or jewelry which
could cause a serious accident.
D. Maintain a clean work area. Avoid accidents by
cleaning up the area and keeping it clean.
E. Stay alert at all times. Know which switch, push
button or control you are about to use and what
effect it is going to have.
F. Disconnect electrical cord for maintenance.
Never attempt to repair or perform maintenance on
the freezer until the main electrical power has been
disconnected.
G. Do not operate under unsafe operating condi-
tions. Never operate the freezer if unusual or exces-
sive noise or vibration occurs.
3.2 OPERATING CONTROLS AND INDICATORS
Before operating the freezer, it is required that the
operator know the function of each operating control.
Refer to Figure 10 for the location of the operating
controls on the freezer. For the information regarding
flashing indicator lights, refer to the troubleshooting
section.
WARNING
THE OFF-ON SWITCH MUST BE PLACED IN THE OFF
POSITION WHEN DISASSEMBLING FOR CLEANING
OR SERVICING. THE FREEZER MUST BE DISCON-
NECTED FROM ELECTRICAL SUPPLY BEFORE RE-
MOVING ANY ACCESS PANEL.
Figure 10. Controls
High Pressure Cutout
Switch Located Back
of Freezer
(Some Models)
ÊÊ
ÊÊ
Ê
OFF-ON
POWER SWITCH
ÊÊ
ÊÊ
Ê
SPIGOT SWITCH
HOLD READY
SWITCH
PUSH TO FREEZE
CLEAN
MIX LOW
ÅÅ
ÅÅ
Å
ÅÅ
ÅÅ
Å
ÅÅ
ÅÅ
Å
ÈÈ
ÈÈ
È
ÇÇ
ÇÇ
Ç
CONSISTENCY/TEMPERATURE
ADJUSTMENT