Filter
Top Products
18
A. DAILY
1. The exterior should be kept clean at all times to
preserve the lustre of the stainless steel. A mild
alkaline cleanser is recommended. Use a soft
cloth or sponge to apply the cleanser.
CAUTION
DO NOT USE ACID CLEANERS, STRONG CAUSTIC
COMPOUNDS OR ABRASIVE MATERIALS TO CLEAN
ANY PART OF THE FREEZER EXTERIOR OR PLASTIC
PARTS.
2. Clean the sani-tray by lifting up,out,and rinsing and
replacing.
B. WEEKLY
1. Check all "O" Rings for excessive wear and replace if
necessary.
C. MONTHLY
CAUTION
THE FREEZER HAS AN AIR COOLED CONDENSER AND
MUST HAVE PROPER AIR CIRCULATION.
DO NOT PLACE THE E257 FLOOR MODEL FREEZER
ANY CLOSER THAN SIX (6) INCHES (15.2 CM) FROM
THE WALL.
THE COUNTER MODEL FREEZER REQUIRES A 3" (7.6
CM) CLEARANCE ON THE SIDES, A 1" (2.5CM) CLEAR-
ANCE AT THE REAR, AND A 10" (25.4 CM) CLEARANCE
AT THE TOP.
FAILURE TO CLEAN THE CONDENSER FILTER MAY
RESULT IN SERIOUS FREEZER DAMAGE AND COULD
VOID THE WARRANTY.
CONDENSER CLEANING
1. For the floor models, remove the sani-tray and
insert. Remove the two phillips head screws from
the lower front panel and pull panel down and out.
Blow the dirt out from the opposite side of the
condenser using an air tank, CO2 tank, or vacuum.
2. For the counter model, remove the six phillips head
screws from the back panel. Then clean the con-
denser using the same method as on the floor model.
3.12 EXTENDED STORAGE
Refer to the following steps for storage of the freezer over
any long period of time:
A. Place the STIRRING ONLY-OFF-STIRRING &
FREEZING switch in the OFF position.
B. Disconnect (unplug) the freezer from the electrical
supply source.
C. With a warm detergent solution, thoroughly clean all
parts that come in contact with neutral base mix or
flavors. Rinse in clear water and dry all parts. Do not
sanitize.
NOTE
Do not let cleaning solution or products stand in the
product cylinder during shutdown period.
D. Remove, disassemble and clean the spigot assem-
blies and lower bushing. Place these parts in a
plastic bag with a moist paper towel to prevent them
from becoming brittle.