Filter
Top Products
PAGE 18 — STOW MS-63 MIXER — OPERATION AND PARTS MANUAL — REV. #5 (03/26/10)
STOW MS-63 PLASTER/MORTAR MIXER — ELECTRIC MOTOR
Special attention should be given to the electric switch as well
as the over-and-under voltage protection devices as per
regulations set forth in the local electrical safety code handbook
NOTE
Figure 7. Single Phase Electric Motor With
12-inch Pigtail
Electric Motor
For maintenance care and operation of the electric motor,
refer to your electric motor instruction booklet furnished with
the motor.
Protect the electric motor from dust as much as possible
and keep ventilating openings clean.
DO NOT spray water at any time on the
electric motor
.
DO NOT operate electric motor in a explosive environment.
The electric motor used in this mixer is a single-phase 3
HP motor. The input voltage requirement for this motor is
115/230 VAC, and has been pre-set to 230VAC.
Electric Motor Connection
A 12-inch electrical cable (Figure 7) is provided with the
electrical motor for hookup to a power source. Table 5 shows
the required NEMA connector for the desired motor
horsepower rating. In addition, Table 5 also shows the
matching NEMA approved connector for the required
extension cord.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
ALWAYS
make certain that the power source required
for the electric motor is
correct
and always use the correct
NEMA configuration plug.
Failure
to supply the correct
voltage to the motor can severely damage the motor.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Electric Motor
Connections
Electric Motor
Safety
It is strongly recommended that all
electrical wiring be done by a
licensed
electrician
.
NOITAMROFNIGNIRIWROTOMCIRTCELE.5ELBAT
rotoM
rewopesroH
gnitaR
esahPelgniS-CAV032-511
rotcennoCgulPAMEN
AMEN
gnitaM
rotcennoCelcatpeceR
PH5.1
)CAV511(
735049MEN/PP02-5L835049MEN/PR02-5L
PH5.1
)CAV032(
935049N/PP02-6L045
049N/PR02-6L