Filter
Top Products
5
Dimensions in parentheses are in
millimeters unless otherwise specified.
SUB-ZERO MODELS 315I AND 315IP INSTALLATION
IMPORTANT NOTE:
The floor under the
i
ce maker must be at the same level as the
surrounding finished floor.
I
MPORTANT NOTE:
W
hen you move the unit
using a hand truck or dolly, position the dolly
on the side of the unit and secure the door so
i
t does not open while transporting the unit.
Any finished flooring should be protected
with appropriate material to avoid any
damage fr
om moving the unit.
MODELS 315I AND 315IP
Overall Width
1
5
3
/16" (386)
Overall Height 33
5
/8" (854)
Overall Depth 24" (610)
Minimum Door Clearance 15
1
/4" (387)
Rough Opening W
idth
1
5
1
/4" (387)
Rough Opening Height 34
1
/2" (876)
Minimum Height Required
(levelers in) 33
3
/4" (857)
Rough Opening Depth 24" (610)
Dimensions may vary ±
1
/8" (3).
O VERALL DIMENSIONS
Models 315I and 315IP
Dimensions may vary ±
1
/8" (3).
33
5
/8"
(854)
15
3
/16"
(386)
29
3
/8"
(746)
4"(102)
33
5
/8"
(854)
19"
(483)
2
1
/8"(54)
SIDE VIEWFRONT VIEW
19"
(483)
TOP VIEW
15
3
/16"
(386)
115˚
DOOR SWING
S
INSTALLATION SPECIFICATIONS
AREA REQUIREMENTS
Before moving the ice maker in place, be sure
the finished opening dimensions, electrical and
p
lumbing locations are accurate. Refer to the
Installation Specifications illustrations on
pages 7–8. The illustrations below provide
o
verall dimensions for Models 315I and 315IP.
Be sure your plumber, electrician and cabinet
installer have this information before finishing
work is completed.
Model 315I is a gravity drain model that
requires a drain tube that is pitched down from
the outlet at the back of the unit to the sanitary
sewer connection. Model 315IP has a built in
drain pump that will pump water up to a drain
point, such as a nearby sink. Refer to specifica-
tions on pages 7–8.
IMPORTANT NOTE:
If the ice maker is
installed in a corner, the door swing may be
limited due to handle contact with the wall or
cabinet face.