Filter
Top Products
Models 424G and 424FSG Installation 7
subzero.com
Electrical Requirements
HOME ALARM SYSTEM
If a home alarm system is to be used, refer to home alarm
connections on page 11. In addition to operating power,
the installer may also be required to supply a home
automation system lead to the unit. This is for a low-
voltage, low-current signal similar to door and window
sensor signals. Common, normally open and normally
closed contact configurations are provided.
Three
1
/4" female spade connectors are located in the
compressor compartment and are accessible behind the
kickplate on models 424G and 424FS. A minimum of 36"
(914) of lead wire should be provided for each contact,
exiting the back wall near the electrical outlet.
Before moving the wine storage unit in to position,
protect any finished flooring with appropriate materials
and secure the door closed.
Moving the Unit
B
efore moving the wine storage unit into position, make
sure all opening dimensions and electrical requirements
are complete and accurate.
IMPORTANT NOTE: The floor under the undercounter unit
must be at the same level as the surrounding finished floor
to allow for removal of the unit for servicing.
Use an appliance dolly to move the wine storage unit near
the installation opening. Position the dolly at the side of
the unit to prevent damage to finished surfaces. Remove
and discard all packing materials and tape.
IMPORTANT NOTE: Do not discard the kickplate, anti-tip
bracket and hardware. These items will be needed for the
installation.
All roller-assembly wine shelves should be removed to
reduce weight and prevent them from rolling. To remove,
pull the shelf out to its full extension, gently and evenly lift
up on both sides of the front of the shelf and remove.
Reverse the procedure to reinstall the shelf.