Sub-Zero 590 Refrigerator User Manual


 
INSTALLATION
INSTRUCTIONS
Figure 12
To
block the unit, using the
wood block and hardware
provided, follow these steps.
1) Locate and mark two wall
studs against the wall where
the refrigerator
is
to be
located.
2)
Locate the proper height
to clear the unit. The space
along the top ofthe Sub-Zero
between the unit
and
the
bottom of the wood block
must
not
be
greater
than
'!4". See Figure 11.
3)
Position the wood block
over the unit and secure it
using the screws
and
"I.:'
brackets provided. Make sure
screws extend a minimum of
7/
B
"
into each ofthe two
wall studs. The wood block
must extend a minimum of
three inches over the unit.
See Figure 11.
4)
Using the front and rear
levelers, the unit must be
raised until it contacts the
wood block. See Figure 12.
I.aWARNINGI
To
reduce
possibility
of
cabinet
tipping
forward,
front
levellers
must
be
In
contact
with floor. See
Figure
12.
Figure
10
Figure
11
BLOCKING
(ALL MODELS)
Step
8
I.aWARNINGI
To
help
prevent
the
unit
from
tipping
forward
under
certain
load
conditions
and
provide
a more stable
Installation, the
unit
must
be
secured
In
place with
a
solid
soffit
or
wood
block.
If
there
Is
a solid soffit
above the unit with
clearance between the unit
andthe
soffit
of
one Inch
or
less,
as
illustrated
In
Figure
3,
you do
not
need to block
the unit.
If
this Is
not
the
case,
YOU
MUST BLOCK
THE
UNIT.
Figure 8
MODEL 590
To
remove Model 590 grille
assembly, the inner grille
panel assembly must first be
removed.
Lift
up
(1),
then pull
out at the bottom
(2),
then pull
top section
down
and out of
the top key slot (3)
(as
in
Figure 9). Next, remove the 5
mounting screws that hold the
outer grille panel assembly to
the top compartment. See
Figure 10.
MODELS 501F
AND
501 R
To
remove
the 501 grille,
remove
two
(black)
screws
located in the lowest louver
in
the grille. Tilt the bottom of the
grille out and away, it will
release from the top of the
grille. There is no grille spring
on
501
Series. See Figure 8.
SHIPPING
STRAP
/
GRILLE REMOVAL
Figure 7
Step 7
Grille removal is necessary
to access power cord,
hook
up
water line and
is
recommended for trans-
porting through doorways.
MODELS
511,532,542,
550
AND
561
Remove center grille screw
and cut the red nylon shipping
strap.
Tilt
the grille forward
and release the spring(s) from
behind the grille. See Figure
7.
Step 6
Remove all packing materials
and
tape.
I.aWARNINGI
To
reduce the
possibility
of
the
unit
tipping
forward,
you
must
reposition
the
front
levelers
to
make
contact
with the floor.
You
will
have to
extend
these
legs
when the
unit
Is finally
positioned.
Figure 9
4