Filter
Top Products
9
KICKPLATE INSTALLATION
Once the unit is leveled and wiring connections
made, the kickplate can be installed. Use the
two #10 x 13 mm stainless steel screws that
are provided with the kickplate. Refer to illus-
tration 8 below.
IMPORTANT NOTE:
The kickplate must be
removed for servicing. The floor cannot inter-
fere with removal. The louvered section of the
kickplate must not be covered so as to prevent
air circulation.
Turn power back on to the electrical outlet.
MODELS ICB424 AND ICB424FS INSTALLATION
Kickplate
Illus. 8
DOOR PANELS – MODEL ICB424
Model ICB424 is offered in two design applica-
tions; stainless steel (/S) and overlay (/O). Each
of these designs are available as a glass door
(G) model.
The stainless steel Model ICB424 is available in
the classic finish only and is shipped from the
factory with the decorative stainless steel door
panel and matching handle in place.
The overlay Model ICB424/O is designed to
accept a decorative door panel to match
surrounding cabinetry. The door panel and
the handle will be provided by the customer.
The solid door Model ICB424S—with no glass
window—requires a different door panel than
the glass door design.
Before beginning installation, check for the
correct components for the fit and finish
desired. All overlay doors require a decorative
panel 603 mm by 764 mm and a minimum
16 mm thick.
If you have questions, contact your Sub-Zero
dealer or cabinet supplier. Additional panel
information can be found in the Sub-Zero
Design Guide.
PANEL
DESIGN
Additional panel
design information
can be found in
the Sub-Zero
Design Guide.
Check our website
at subzero.com.
MODELS
ICB424
ICB424FS