Filter
Top Products
STATIONARY SHELF
The stationary glass shelf, with 686 mm wide
tall units and Model ICB736TR, is packed on
the top shelf of your Integrated tall unit. Place
this shelf on the bottom portion of the top
compartment with the beveled edge of the
shelf support facing front. When installed
properly, the rear support legs will space the
shelf away from the back wall to ensure an
even flow of air through the unit.
DOOR SHELVES
The door shelves and dairy com partment of
Integrated tall units are adjustable within the
guides of the door liner.
To remove door shelves or the dairy compart-
ment, lift straight up and out from the bottom
as shown in the illustration below.
To replace, select a desired position and slide
the door shelf or dairy compartment down into
the guides.
13
TOP COMPARTMENT STORAGE
ADJUSTABLE GLASS SHELVES
You can remove or adjust the tempered glass
shelves of the Integrated tall units. First, tilt the
shelf up at the front, then lift it up and out of
the tracks on the rear wall of the refrigerator or
freezer, as shown in the illustration below.
To clear the door shelves, lift and pivot the
end of the glass shelf nearest the door upward,
and remove.
To replace the glass shelves, select the desired
shelf height. Then, with the front of the shelf
raised slightly, place the shelf in the tracks on
the rear wall of the unit. Lower the front of the
shelf until it locks into position.
SUB-ZERO INTEGRATED USE & CARE
Always exercise care when handling the
glass shelves to prevent breakage or
scratching the interior.
Adjustable glass shelf removal Door shelf removal
Intl Integrated UCI.qxp:Intl Integrated UCI 5/27/08 2:31 PM Page 13