Filter
Top Products
Wine Storage 64
Model ICBWS-30
DUAL FLUSH INSET PANELS
When installing two models ICBWS-30 or a model
ICBWS-30 and built-in unit side by side in a flush inset
application, you must decrease the width of the decorative
flush inset panels by 13 mm. Adjustments to the panel
offsets will also need to be made. These adjustments are
needed to achieve a proper fit and to ensure the panels do
not collide when closing. Panel dimensions in the chart
below have been adjusted to reflect the decrease in panel
dimensions.
IMPORTANT NOTE: If a filler strip is not used, dual instal-
lations can only be accomplished using two units with
opposite hinges.
Illustrations A–E provide panel offsets and reveals for
model ICBWS-30 in a flush inset application. Refer to the
chart below for reference to the illustrations. All reveals are
13 mm unless otherwise specified.
For additional information on panel reveals, visit the speci-
fication library section of our website, subzerotrade.com.
16
mm
8 mm
13
mm
FLUSH INSET PANEL
SPACER
BACKER
DOOR / DRAWER / GRILLE
TOP VIEW
CABINETRY
Illus. A Illus. B
DUAL
TRIM
6 mm
REVEAL
8 mm
3 mm
DOOR DOOR
TOP VIEW
Do not exceed the flush inset decorative panel
dimensions. Exceeding dimensions could cause
damage to the panels and the Sub-Zero unit.
13 mm
8
mm
3
mm
CABINETRY
GRILLE
SIDE VIEW
Illus. C Illus. D
13 mm
2
mm
8
mm
8
mm
4
mm
GRILLE
DOOR
SIDE VIEW
8
mm
2
mm
DOOR /
DRAWER
SIDE VIEW
Illus. E
Panel Offsets Illus.
MODEL ICBWS-30
Doors (hinge) /Grille Sides A
Doors (handle) Sides B
Grille Top C
Grille Bottom / Door Top D
Door Bottom E