Filter
Top Products
8
|
Sub-Zero Customer Care 800.222.7820
WATER FILTER REPLACEMENT
1 To access the water lter, pull out on the bottom edge
of the grille and rotate upward.
2 To remove the old lter, rotate counterclockwise one-
quarter turn, then pull out. Refer to the illustration below.
It is normal for a small amount of water to drip when
the lter is removed. It should be wiped up with a paper
towel or cloth.
3 Remove the new lter from packaging and remove the
plastic cap.
4 Insert the new lter into the manifold and turn clockwise.
5 Once the new lter has been installed, the water lter life
monitor will automatically reset.
Water Filtration System
The water ltration system of Sub-Zero PRO 48 models
supplies ltered water to the ice maker to produce great-
tasting ice.
IMPORTANT NOTE: When using the water ltration system
for the rst time and after lter replacement, it is necessary
to clear any air from the system and allow the lter to assist
in cleaning the water lines. Discard the rst two full con-
tainers of ice.
If the water ltration system will not be utilized, it can be
placed in water lter bypass mode by removing the lter.
The lter is rated for 750 gallons
(2839 L) or one year,
whichever comes rst. When the lter needs to be replaced,
‘REPLACE FILTER’ will be visible in the external display.
Replacement Sub-Zero water lters can be ordered online
at subzerowolfstore.com. For questions, contact Sub-Zero
customer care at 800-222-7820.
OPERATION
Open grille.
Water lter removal.
WATER FILTER