Filter
Top Products
19
Vertical drawer adjustment Horizontal drawer adjustment Horizontal drawer adjustment
DRAWER ADJUSTMENT
Check to make sure that all drawers are
properly adjusted. If not, vertical and horizon-
tal adjustments can be made to the drawers.
VERTICAL ADJUSTMENT
The drawer must be removed to make vertical
adjustments. To remove the drawer, pull the
drawer all the way out until it stops, lift up
evenly on both sides of the drawer front and
pull out.
Loosen the three drawer slide mounting
fasteners. Using a 11 mm open-end wrench,
turn the adjustment fastener to the desired
position and retighten the fasteners. Refer to
the illustration below.
To reinstall the drawer, raise the front of the
drawer and place onto the drawer slide tracks.
Be sure to engage the front of the drawer slide
with the drawer assembly.
Check alignment of the automatic drawer
closer. If the closer catch does not align with
the closer pin, adjust the position of the auto-
close mechanism.
HORIZONTAL ADJUSTMENT
The drawer must be removed to make horizon-
tal adjustments. To remove the drawer, pull the
drawer all the way out until it stops, lift up
evenly on both sides of the drawer front and
pull out.
Loosen the screws on the front two slides,
then move adjustments blocks to the desired
position and retighten the screws. Refer to the
illustration below.
Release the rear adjustment block by disen-
gaging the snaps. Move the block forward to
shift drawer to the right and back to shift
drawer to the left. Each position will move the
drawer 0,8 mm. Refer to the illustration below.
Snap the block over the pins located on the
rear adjuster. Both sides should be moved in
the same direction.
To reinstall the drawer, raise the front of the
drawer and place onto the drawer slide tracks.
Be sure to engage the front of the drawer slide
with the drawer assembly.
PRO 48 INSTALLATION INSTRUCTIONS