Filter
Top Products
15
Dimensions in parentheses are in
millimeters unless otherwise specified.
I
nstall the door panel by engaging the tabbed
bracket to the door first and then sliding the
hinge side hardware over the positioning
screws. You will have a
1
/4" inch adjustment,
up and down, side to side, with this hardware.
Once you have the door in place, attach the
remaining #8 x
1
/2" screws to the hinge side
mounting bracket and install decorative caps.
9
0 - D E G R E E D O O R S TO P
The Sub-Zero ice machine has a 90-degree
door stop. Follow these steps for installation:
1)
Open the door approximately 80 degrees.
2)
Insert the stop pin into the bottom door
hinge (pin enters from the top). The pin
must be inserted until the head has made
contact with the hinge body. Refer to the
illustration below.
3)
Insert the stop pin into the top door hinge
(pin enters from the bottom).
4)
Check for proper operation.
H I N G E C O V E R I N S TA L L AT I O N
IMPORTANT NOTE:
Install the hinge covers
after installation of the ice machine is
complete. The 90-degree door stop must be
installed prior to installing the hinge covers.
1)
Remove the backing paper of the adhesive
pads and bond to the hinge.
2)
Install center covers (magnets will secure
these covers). Refer to the illustration
below.
IMPORTANT NOTE:
Hinges must be free of
dirt or grease before applying covers.
IMPORTANT NOTE:
It will be necessary to
remove the knock-out in the hinge cover when
the 90-degree door stop is used.
Door Stop Pin
Knock-Out
90-degree door stop
Hinge cover installation
If the reveal on the hinge side of the door
panel is less than
1
/
4
", and the panel has
a square corner, severe finger pinching or
damage to the unit may occur.
Exercise caution when drilling holes for
mounting hardware. This is especially
critical with inset panels.
I
N STA LL AT IO N
S U B - Z E R O I CE M ACH IN E I N S TA L L AT I O N