Filter
Top Products
Felix Storch, Inc.
SUMMIT PROFESSIONAL DIV.
Page 13
BI605FF Series
These refrigerator-freezers are fully automatic defrost refrigerator-freezers. They utilize a digital thermostat with a built-in
defrost-timer (mounted in the kick-plate) to intermittently turn off the refrigeration system long enough for the freezer plate to
melt accumulated ice. The melted water is drained out of the appliance through the metal tray below the freezer compartment to
a plastic tray above the compressor where the water is evaporated. During the cooling cycles, it is normal to see a small ice
accumulation on the freezer floor. Be sure to keep the path for water removal clear, and the metal tray properly seated. The
digital thermostat will display “DEF” during the defrost function.
The auto-defrost feature adds convenience, but it is not recommended for uses where critical medicine, pharmaceuticals or
vaccines need to be kept frozen. A manual or frost-free freezer compartment or a separate freezer is more suitable for these
applications. SUMMIT has a full range of such products.
To set the interior temperature, (it should be set only for the fresh food section) follow the instructions for digital thermostats.
Model BI605FF does not include a vegetable crisper as a standard feature.
FS62BI Series
These freezers are manual defrost, commercial freezers capable of operating at -25°C (-13°F). Follow the defrosting
instructions found earlier in the booklet; being careful not to use sharp objects to scrape the ice. The cooling coils (part of the
sealed refrigeration system) run through each fixed shelf. The drawers are fully removable, and you can operate the freezer
without them if desired. However, the drawers contribute to energy efficiency and are best used whenever possible. The
thermostat is located on the exterior front of the unit in the face of the tabletop. In some cases, on models with the CSS suffix, or
models modified for ADA applications, the thermostat is housed on the rear of the unit, near the top. It is convenient to set it
prior to installing (many customers will be satisfied with a warmer set-point, which is still colder than many household freezers).
Shelf positions in FS62BI models are fixed in position.
OUTDOOR REFRIGERATORS
(BRANDED SUMMIT OR OTHER BRANDS)
(SPR7OS Series, SPR7OSBI series, SPR601OS Series, SCR600LOS Series and Drawer series)
Models for outdoor use all contain the same internal defrost system as the FF7BI series on the prior pages. Your unit may have
a light controlled by a rocker switch, an automatic switch or no light. (Drawer units are not equipped with lights). Read directions
earlier in this booklet, specifically on the use of GFCI outdoor cord, location requirements, tip-over brackets for drawer units,
drawer removal and replacement and safety. These refrigerators are not designed to operate when exterior temperatures are
below 45 degrees F. If you have seasons with temperatures routinely that low, these units should be unplugged, cleaned and
stored for the winter. Always leave the door slightly ajar during storage so odors will not build-up inside the units. Once a
season, when foods are not present, (prior to winter storage is ideal) the stainless steel exterior of the units can be lightly coated
with WD-40 to restore the luster and protect the finish. A vinyl cover for the SPR7-OS series can be ordered from your dealer, or
from www.summitapplianceparts.com
. Drawer refrigerators and SPR7-OSBI models are suitable for under-counter or built-in
applications. SPR7-OS models, and SCR600LOS series and SPR601OS series are intended for free-standing use, and if put
under a counter, provisions for adequate air flow must be provided (minimum 1 inch on sides and top and 2 inches in the rear).
FOR BEST PERFORMANCE OF OUTDOOR REFRIGERATORS;
• KEEP OUT OF DIRECT SUNLIGHT
• ALLOW ADEQUATE AIR CIRCULATION
• DO NOT USE WITH A SWITCHED OUTLET
• CHECK GFCI CORD REGULARLY
• MINIMIZE DOOR OPENING TIME
• ALLOW 24 HOURS TO COOL A FULL LOAD OF ROOM TEMPERATURE BEVERAGES
APPLIANCE OPERATION