Filter
Top Products
Knives:
Plug the electrical cord into a 120 volt, 60 cycle AC outlet.
Press down on the can opener lever to start the grinding wheel. Allow
the motor to develop full speed.
Insert the knife into either slot of the sharpening guide, holding it flat
against the sloping wall of the housing. Lower the blade until it touches
the wheel.
Draw the knife blade towards you (I), keeping the blade against the
sloping wall of the housing.Maintain only a slight pressure on the wheel.
Repeat the same operation using the other slot. Alternate the knife blade
from slot to slot to sharpen both sides of the blade. Continue this
process until the desired sharpness is achieved.
SCiSSOrJ:
Press down on the can opener lever to start the grinding wheel. Allow
the motor to develop full speed.
Open scissors, hold blade to be sharpened with the other blade on the
bottom. Pull blade through slot from left to right (Jj.
Turn scissors over and repeat with other blade. Use light pressure and
continuous motion when sharpening.
Cord Storage:
A cord storage area is located on the bottom of the unit to store excess
cord. When the cutting assembly is raised, pull out as much cord as
required to reach the outlet.
01995 Sunbeam-Oster Household Products.
Sunbeam@ is a registered trademark of Sunbeam Corporation. All rights reserved.
Distributed by Sunbeam-Oster Household Products, Schaumburg. IL 60173
P.N. 61659
38637~OWli-SUNS