Filter
Top Products
5
OPERATION OF YOUR CORDLESS KETTLE
PRIOR TO FIRST USE
It is recommended that you clean your new kettle thoroughly before using it for the first time.
To do this, fill the kettle with fresh water and boil. Discard the water and repeat. Discard the
water and rinse the kettle with cold water. Follow the instructions as stated below.
INSTRUCTIONS FOR REGULAR USE
1. To fill the Kettle, hold and gently squeeze
the handle. The Spout Cover will open.
2. Fill with the desired amount of water.
Note: Do not fill with less than the minimum
level as indicated on the Kettle, or more
than the maximum level as the water
may spill over when boiling.
3. Plug Power Base cord into a power outlet.
4. Position the Kettle onto the Power Base
so that the Switch Housing rests over
the Switch. Press the ON/OFF Switch
downwards, located at the back of the Kettle.
The water will start heating and the Kettle
will switch off automatically once the water
has boiled.
Note: Ensure that the reset lever is clear of
obstructions. The Kettle will not turn off
if the reset lever is constrained.
5. Lift the Kettle from the Power Base and pour
the water.
6. The Kettle can be stored on the Power Base
when not in use. The Kettle will not
re-boil until the ON/OFF Switch is
pressed downward.
Note: Ensure the power is turned off when
kettle is not in use.
Should you accidentally allow the Kettle to
operate without water, the boil dry mechanism
will operate. If this should occur, allow the
Kettle to cool before filling with cold water
and re-boiling.
Cord Storage Facility
Excess cord can be stored by feeding the
cord into Storage Cavity underneath the
Power Base. Select any one of the 3 cord
exits most convenient to connect the cord to
a power outlet.
Mineral deposits in tap water may cause the
water gauge and the inside of the Kettle to
discolor after frequent use. To remove this
build-up, fill the Kettle with 3 cups of white
vinegar and the remainder with water and
allow to stand overnight.
Empty the solution from the Kettle. Any stain
remaining just inside the spout can be
removed by rubbing with a damp cloth.
Fill the Kettle with clean water and bring to boil
.
Repeat and the Kettle will be then ready to use.
Always disconnect the appliance from the
power point before cleaning. Never immerse
the Kettle Switch area, cord, or the Cordless
Power Base in water or allow moisture to come
into contact with these parts.
The outside of the Kettle can be wiped over
with a damp cloth.
CAUTION. Never use any chemical, steel
wool, or abrasive cleaners to clean the outside
of the Kettle.
CARE AND CLEANING OF YOUR CORDLESS KETTLE