Filter
Top Products
Using your Sunbeam Open All
4
1. Ensure that the Cutting Assembly is
correctly positioned. (See figure 1.)
The Cutting Assembly fits into the
keyhole opening at the top of the Open
All
™
can opener, above the Drive Wheel.
Slide the Release Button to the right as
the Cutting Assembly is inserted, it will
“click” into position, with the release
button returning to its original position.
2. Insert the plug into a 230-240 volt
power outlet and turn the power on.
3. Hold the Lever in the upright position.
Position the can under the Support Bar
so that the rim of the can rests on top
of the Drive Wheel, tilting the can at a
slight angle towards the main body of
the unit. (See figure 2.)
4. Firmly press the Lever down. This action
will bring the blade down and pierce
the lid of the can and start operating
the motor to turn the can. Ensure the
Magnetic Lid Holder is in contact with
the lid of the can. (See figure 3.)
5. When the can begins to turn, it is no
longer necessary to hold down the Lever.
6. When the can is fully opened, the Open
All
™
can opener will stop automatically.
Figure 2
Support
Bar
Lever
Drive
Wheel
Figure 1
Drive Wheel
Keyhole
Release Button
Figure 3