Filter
Top Products
9
Fitting the attachments
Before removing any attachment, ensure the
plug is disconnected from the power outlet.
Always allow the unit and the attachment to
cool completely before handling.
Fitting the standard nozzle
1. Attach the standard nozzle to the Eco
Jet by pushing it onto the steam outlet,
aligning the arrow engraved on the
attachment with the join line above the
steam outlet. Turn the attachment in the
direction of the arrow until it locks into
place and the arrow on the attachment
aligns with the double line marked on the
side of the steam outlet.
2. To remove the standard nozzle, twist the
attachment back against the direction
of the arrow. When the arrow engraved
on the attachment is aligned with the
join line above the steam outlet, pull the
attachment firmly to remove.
Fitting the utility head and fabric cloth
1. Fit the fabric cloth to the utility head by
stretching the elasticised cloth over it,
ensuring it is evenly fitted and quite snug.
Note: Do not use the utility head without a
cloth attached as this may cause damage to
surfaces.
2. Attach the utility head with cloth to the
Eco Jet by pushing it onto the steam
outlet aligning the arrow engraved on the
attachment with the join line above the
steam outlet. Turn the attachment in the
direction of the arrow until it locks into
place and the arrow on the attachment
aligns with the double line marked on the
side of the steam outlet.
Note: When cleaning large areas the cloth
may become quite wet and/or dirty. Switch
the unit off at the outlet, wait for the
attachment and the cloth to cool completely
before removing the cloth to rinse, wring
out and replace. Alternatively replace with a
clean, dry cloth.
3. To remove the utility head, twist the
attachment back against the direction
of the arrow. When the arrow engraved
on the attachment is aligned with the
join line above the steam outlet, pull the
attachment firmly to remove.
Fitting the utility head and squeegee
The squeegee works in conjunction with the
utility head and needs to be attached to it
before being mounted to the unit.
1. Fit the squeegee to the utility head by
aligning the hooks on the squeegee with
the holes on the utility head.
2. Push the top of the utility head down so
that it is secured under the clip on the top
of the squeegee.
3. Attach the utility head with squeegee to
the Eco Jet by pushing it onto the steam
outlet aligning the arrow engraved on the
attachment with the join line above the
steam outlet. Turn the attachment in the
direction of the arrow until it locks into
place and the arrow on the attachment
aligns with the double line marked on the
side of the steam outlet.
4. To remove the squeegee from the utility
head lift the clip on the top of the
squeegee up and pull away from the
utility head.
Using your Eco Jet continued