Filter
Top Products
16. After 2 minutes stop the machine by
flicking the power switch on the machine to
the ‘Off’ position. Now that the machine is
off, turn the selector dial to the setting.
17. Leave the machine off for 10-15 minutes
to allow the descaler to take affect.
18. Flick the power switch ‘On’ and allow
1
/
2
of
the rest of the descaler solution to run
through the brewing head, then turn the
selector dial immediately to the setting.
Steam for 3-4 minutes.
19. To finish, turn the selector dial to the
setting and allow the remaining water in
the reservoir to run through the brewing
head.
20. Remove and empty the containers placed
under the brewing head and steam nozzle.
Once emptied, once again place one under
the brewing head and the other under the
steam nozzle.
21. Remove the water reservoir from the
machine and rinse thoroughly under
running water, ensuring that all traces of
the descaling solution is removed. Fill the
water reservoir with clean water and place
onto the machine.
22. Run two (2) full water reservoirs through
the brewing head. Refill the water reservoir
and run the steam nozzle for 4-5 minutes.
Note: Ensure that you continue to run water
through the machine until the water runs clean
and clear.
23. When this is finished, remove the water
reservoir and set aside. Remove the water
containers and give the machine a good
wipe over.
24. Turn the machine upside down. The
machine should now be on the warming
plate resting on the cloth/tea towel once
again.
25. Carefully replace the rubber seal, filter,
washer and screw. Tighten well.
26. Turn the machine upright, so that it is now
sitting correctly on the bench.
27. Replace the drip tray and froth enhancing
steam attachment onto the steam nozzle.
28. Fill the water reservoir with water and
position it on to the machine.
18
Descaling (continued)