Filter
Top Products
14
1. ESPRESSO FUNCTION
For best results, it is ideal to pre-heat your
cups, filter handle and filter as follows:
• Insert the power cord into a 230-240V AC
power outlet and turn the power on.
• Fill the water reservoir (1) (2), (3) (4) (5)
with cold water and start the appliance (6).
• Put the filter handle and an empty filter
in place (7) (8) (9), and place cups
underneath the filter handle.
• When the machine is ready, the orange
‘Warm Up’ light goes off, turn the
operating dial to
setting (11).
• When the cups are full of hot water,
return the operating dial to the ’off’
position.
Note: Once the appliance has been on for
a while, the coffee cups can be warmed
by placing them upside down on the cup
warming plate (12).
Preparing an espresso:
• Insert the power cord into a 230-240V AC
power outlet and turn the power on.
• Fill the water reservoir (1) (2), (3) (4) (5)
with cold water.
• Start the unit (6). The red ‘Power’ light
and orange ‘Warm Up’ light will both
illuminate.
• Pre-heat your coffee cups by placing them
upside down on the cup warming plate (12).
• Select the required filter (7) for 1 or 2
cups of coffee and place in the filter
handle.
• Using the measuring spoon supplied, place
one or two measures of ground coffee into
the filter (13). With the other end of the
measuring spoon, use the tamper to push
(pack) down the coffee grinds (14).
Important: Be sure not to over-fill the filter
with too much coffee, and wipe around the
edge of the filter to remove any coffee grinds
(15).
• Place the filter handle on the machines
brewing head. Position the handle so it
points to the left, place the filter handle
flat against the brewing head, then turn
the handle towards the right (16) as far as
it can go.
Note: Do not over tighten.
• Place 1 or 2 pre-heated cups below the
pouring spouts.
• When the Sunbeam Café Latte is at the
correct temperature the orange ‘Warm Up’
light will go out, then turn the operating
dial to the setting (17). You will hear
the machine making a pumping noise, this
is normal.
• Once the cup/s are filled to the desired
level, turn the operating dial to the ‘off’
position.
• Remove the filter handle and the filter by
turning the filter handle to the left.
• To remove the used coffee grinds from the
filter, simply turn the filter handle upside
down in a bin and gently tap out the
coffee (18).
Functions of your Café Latte