Filter
Top Products
How to use your Sunbeam Citrus Juicer.
Before use
Before using your Sunbeam citrus juicer for the
first time, apart from the motor base, wash all
parts in warm soapy water. Rinse and dry
thoroughly.
1. Place the citrus juicer jug onto the
motor base.
2. Select the cone size desired, depending on
the size of fruit you are going to juice.
3. Cut citrus fruit in half, cutting across
segments.
4. Plug the power cord of the citrus juicer into
a 230-240V power outlet and turn power on.
5. Press fruit down onto the cone and the
juicing action will start automatically.
6. Lift the fruit off the cone and juicing action
will stop automatically.
Juicing Tips.
• Fruit juiced at room temperature will yield
more juice.
• Roll fruit between palm of your hand and
the bench top before cutting, to loosen
fibres.
• Push fruit from side to side against cone
while juicing to extract all the juice.
Care and Cleaning.
Unplug and remove all parts from the motor
base before cleaning.
Motor Base
Wipe with a damp cloth. Never immerse in
water or other liquids. Never use harsh
abrasives or detergents.
Jug, Pulp Basket, Cover and Juicing Cones
Wash in warm to hot water using a mild
detergent.
Note: Do not wash any parts of the citrus juicer
in a dishwasher. The hot water temperature
and harsh detergents may ultimately warp or
scratch these parts.
Storage
Sunbeam suggests your citrus juicer be kept on
a dry bench top in your kitchen, where it will
always be ready for use. The cover will keep
your citrus juicer free from dust.
Sunbeam is a registered trademark. Made in China. Due to
minor changes in design or otherwise, the product may
differ from the one shown in this leaflet. Approved by the
appropriate Electrical Regulatory Authorities. Backed by
Sunbeam‘s 12 Month Replacement Guarantee and National
Service Network.
© Copyright. SUNBEAM CORPORATION LIMITED 2001.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
For more information or advice on any Sunbeam products,
contact the Sunbeam Consumer Service Line on 1800 025 059
in Australia. In New Zealand - contact the Sunbeam Office in
Auckland on 09 912 0747.