Filter
Top Products
Note: The Cafe Juice™ should be completely
assembled before use, if this is not the case
see ‘Assembling your Sunbeam Cafe Juice™
on page 7.
1. Ensure the control switch on the juicer is
in the ‘Off’ position and insert the power
cord into a 230-240V AC power outlet and
turn the power ‘On’.
2. Clean fruit and vegetables thoroughly,
ready for juicing.
Note: The extra large feed chute allows
whole fruit and vegetables to be juiced,
however some fruit and vegetables may
require other preparation before juicing,
such as peeling and removing stones, see
‘Juicing speed guide’ on page 10 for our
recommendations.
3. Ensure that the juicer has been assembled
completely and correctly, making sure
that the stainless steel blade and filtering
basket revolves properly before placing fruit
and vegetables in the juicer.
Note: The stainless steel blade and filtering
basket should be cleaned thoroughly before
each use, see ‘Care and cleaning’ on page
12.
4. Place a jug or glass under the juice spout.
5. Select ‘Low’ or ‘High’ speed with the control
switch. To select ‘Low’ speed push the
control switch down. To select ‘High’ speed
push the control switch up.
For optimum juicing results ‘Low’ speed is
used primarily for soft fruit and vegetables,
particularly those with a high water content
and ‘High’ speed is ideal for hard and
fibrous fruit and vegetables. A list of fruit
and vegetables commonly used for juicing
and their recommended juicing speed are
specified in the ‘Juicing speed guide’ on
page 10.
Important: Do not operate for more than 20
seconds at a time when juicing heavy loads.
None of the recipes in this manual are
considered a heavy load.
6. With the juicer in operation, place the
fruit and vegetables into the feed chute.
Using the food pusher, guide the fruit and
vegetables down the feed chute and onto
the stainless steel blade.
Tip: For maximum juice extraction, guide
the food pusher down the feed chute in a
slow downward motion.
Important: This juicer is protected by an
overload switch which will activate in the
event of heavy loads. Should this occur
unplug the juicer allow it to cool down and
press the re-set button located underneath
the machine.
Important: Do not push fruit or vegetables into
the feed chute with your fingers, always use
the food pusher provided.
7. The juice from the fruit and vegetables will
flow directly into the jug or glass and the
pulp will be separated and collected in the
pulp container.
Important: When juicing be aware of the level
of pulp in the pulp collection container,
because if the container is overfilled this can
cause damage to the appliance and prevent
the juicer from operating correctly.
8. When juicing is complete ensure that the
juicer is switched ‘Off’ and unplugged from
the power outlet.
Operating your Sunbeam
Cafe Juice
™
9