Filter
Top Products
9
Note: The juicer should be completely assembled before
use, if this is not the case see ‘Assembling your Café
Series™ Juice Extractor' on page 7.
1. Ensure the control switch on the juicer is in the ‘Off’
position and insert the power cord into a 230-240V
AC power outlet and turn the power ‘On’.
2. Clean fruit and vegetables thoroughly, ready for
juicing.
Note: The extra large feed chute allows whole fruit
and vegetables to be juiced, however some fruit
and vegetables may require other preparation before
juicing, such as peeling and removing stones,
see ‘Juicing speed guide’ on page 10 for our
recommendations.
3. Ensure that the juicer has been assembled
completely and correctly, making sure that the
stainless steel blade and filtering basket revolves
properly before placing fruit and vegetables in the
juicer.
Note: The stainless steel blade and filtering basket
should be cleaned thoroughly before each use, see
‘Care and cleaning’ on page 12.
4. Place a jug or glass under the juice spout.
5. Select ‘Low’ or ‘High’ speed with the control switch.
To select ‘Low’ speed push the control switch down. To
select ‘High’ speed push the control switch up.
For optimum juicing results ‘Low’ speed is used
primarily for soft fruit and vegetables, particularly
those with a high water content and ‘High’ speed is
ideal for hard and fibrous fruit and vegetables. A list
of fruit and vegetables commonly used for juicing and
their recommended juicing speed are specified in the
‘Juicing speed guide’ on page 10.
Important: Do not operate for more than 20 seconds at
a time when juicing heavy loads. None of the recipes
in this manual are considered a heavy load.
6. With the juicer in operation, place the fruit and
vegetables into the feed chute. Using the food
pusher, guide the fruit and vegetables down the feed
chute and onto the stainless steel blade.
Tip: For maximum juice extraction, guide the food
pusher down the feed chute in a slow downward
motion.
Important: Do not push fruit or vegetables into the
feed chute with your fingers, always use the food
pusher provided.
7. The juice from the fruit and vegetables will flow
directly into the jug or glass and the pulp will be
separated and collected in the pulp container.
Important: When juicing be aware of the level of
pulp in the pulp collection container, because if
the container is overfilled this can cause damage to
the appliance and prevent the juicer from operating
correctly.
8. When juicing is complete ensure that the juicer is
switched ‘Off’ and unplugged from the power outlet.
Operating your Café Series
™
Juice
Extractor