Filter
Top Products
Before Using your kettle
It is recommended that you clean your kettle
before use by boiling a full kettle of water
then discarding the water.
Using your kettle
1. To fill the kettle, remove it from the power
base and lift the lid. Fill with the desired
amount of water. Alternatively, the kettle
may be filled through the spout.
Always fill the kettle between the minimum
and maximum marks. Too little water will
result in the kettle switching off before
the water has boiled. Too much water may
cause it to spill out of the spout when
boiling.
Ensure that the lid is firmly in place before
placing the kettle on the power base.
2. Connect the 3 pin plug into a 230-240
volt AC power outlet. Turn the power ON.
3. Position the kettle on the power base.
Press the ON/OFF button. The power
indicator light will light up. The kettle will
swich off automatically once the water has
boiled.
Note: Ensure that the ON/OFF switch is
clear of obstructions and the lid is firmly
closed. The kettle will not turn off if the
switch is constrained or if the lid is left
open.
4. Lift the kettle from the power base and
pour the water.
Note: Use caution when pouring the water
from your kettle, as boiling water will
scald.
5. The kettle may be stored on the power
base when not in use. The kettle will not
re-boil until the ON/OFF switch is pressed
downward.
NOTE: Ensure the power is turned OFF
while the kettle is not in use.
Should you accidentally allow the kettle to
operate without water, the boil-dry protection
will automatically switch it off. If this should
occur, allow the kettle to cool before filling
with cold water and re-boiling.
Cord Storage Facility
Excess cord can be stored by feeding the
cord into the storage cavity underneath the
power base.
4
Using your Cordless Filter Kettle