Filter
Top Products
6
Before using your kettle.
It is recommended that you clean your
kettle before use by boiling a full kettle of
water then discarding the water.
Operation of your kettle
1. To fill the kettle, remove it from the power
base and lift the lid. Fill with the desired
amount of water. Alternatively, the kettle
may be filled through the spout. Always
fill the kettle between the minimum and
maximum marks. Too little water will result
in the kettle switching off before the water
has boiled.
NOTE: Do not fill the kettle over the
maximum level, as water may spill out of
the spout when boiling. Ensure that the lid
is firmly in place before placing the kettle
on the power base.
2. Connect the plug into 230/240 Volt AC
power outlet. Turn the power ON.
3. Position the kettle on the power base.
Press the ON/OFF button on the handgrip.
The power indicator light will light up. The
kettle will switch off automatically once the
water has boiled.
NOTE: Ensure that the ON/OFF switch is
clear of obstructions and the lid is firmly
closed. The kettle will not turn off if the
switch is constrained or if the lid is left
open. Do not remove the kettle from the
power base, while in use.
4. Lift the kettle from the power base and
pour the water.
NOTE: Use caution when pouring the water
from your kettle, as boiling water will
scald.
5. The kettle may be stored on the power
base when not in use. The kettle will not
re-boil until the ON/OFF switch is pressed
downward.
NOTE: Ensure the power is turned OFF at
the power outlet while the kettle is not in
use.
Should you accidentally allow the kettle
to operate without water, the boil-dry
protection will automatically switch it off.
If this should occur, allow the kettle to
cool before filling with cold water and re-
boiling.
Cord Storage Facility
Excess cord can be stored by feeding the
cord into the Storage Cavity underneath the
Power Base.
Using your Quantum Kettle
360° power base