Filter
Top Products
4
Before using your kettle.
It is recommended that you clean your kettle
before use by filling the kettle with water, up
to the maximum level indicator, boil and
discard.
Using your kettle.
1.To fill the kettle, remove it from the power
base and lift the lid, by pressing the
button on the handle. Alternatively, the
kettle may be filled through the pouring
spout.
2.Fill the kettle with the desired amount of
water. Always fill the kettle between the
minimum and maximum marks. Too little
water will result in the kettle switching off
before the water has boiled.
NOTE: Do not fill the kettle over the
maximum level, as water may spill out of
the spout when boiling.
3.Push the lid closed firmly until it locks
into position.
4.Place the kettle on the power base and
connect the plug into a 230/240 Volt AC
power outlet. Turn the power ON.
5.Press the ON/OFF button downwards at the
top of the handgrip. The power indicator
light will illuminate to indicate the kettle is
heating. The kettle will switch off
automatically once the water has boiled.
NOTE: Ensure that the ON/OFF switch is
clear of obstructions and the lid is firmly
closed. The kettle will not turn off if the
ON/OFF switch is constrained or if the lid
is left open. Do not remove the kettle from
the power base while in use.
6.Lift the kettle from the power base and
pour the water.
NOTE: Use caution when pouring the water
from your kettle, as boiling water will
scald.
7.The kettle may be stored on the power
base while not in use. The kettle will not
re-boil until the ON/OFF switch is pressed
downward.
NOTE: Ensure the power is turned off at the
power outlet when the kettle is not in use.
Should you accidentally allow the kettle to
operate without water, boil-dry protection
will automatically switch it off. If this
occurs, allow the kettle to cool before
filling with cold water and re-boiling.
Cord Storage Facility.
Excess cord can be stored by winding the
cord around the storage facility underneath
the power base.
Using your Quantum Evo
360° power base