Filter
Top Products
6
Always disconnect the kettle from the
power outlet before cleaning.
Never immerse the kettle switch area, cord
or power base in water, or allow moisture
to come into contact with these parts.
Removal of mineral deposits.
Mineral deposits in tap water may cause
the interior of the water gauge to discolour.
To remove this build-up, use Sunbeam
Liquid Descaler, a simple to use, non-toxic
cleaner available from Sunbeam Appointed
Service Agents.
Alternatively:
1.Fill the kettle with 3 cups of white vinegar
and the remainder with water and allow to
stand overnight. DO NOT BOIL.
2.Empty the solution from the kettle. Fill the
kettle with clean water, bring to boil and
then discard the water. Repeat and the
kettle will then be ready to use.
To clean the polished exterior.
The stainless steel surface may be wiped
over with a damp cloth and polished with a
soft dry cloth.
CAUTION: Do not use chemical, steel wool,
or abrasive cleaners to clean the outside of
the kettle, as these will scratch the
stainless steel surface.
To clean the mesh filter.
Push the lower section of the switch at the
top of the handle to open the hinged lid.
Grasp the top of the scale filter and pull
upwards to remove. Wash in warm soapy
water and dry thoroughly before replacing
in the kettle.
Cleaning the concealed heating element
This kettle features a non-corrosive
stainless steel heating element. Over time,
scale may build up on the concealed
element inside the kettle, causing
discolouration that may have the
appearance of rust. Be assured this is not
rust. If this occurs clean with a green
Scotchbrite
®
scourer or similar and a
suitable abrasive cleaning cream. Rinse
and clean thoroughly with tap water before
using your kettle again.
Care and Cleaning