Filter
Top Products
C
LEANING
Y
OUR
E
LECTRIC
K
ETTLE
B
EFORE
F
IRST
U
SE
1.Wash the inside of the kettle and lid with mild detergent and water.
Rinse each thoroughly.
DO NOT IMMERSE THE KETTLE OR
POWER BASE IN WATER OR ANY OTHER LIQUID.
THESE ITEMS ARE NOT DISHWASHER SAFE.
2.Fill the electric kettle with fresh water to the “MAX” water level mark.
Plug power base
(For cordless model only)
or kettle
(For models with cord only)
into power outlet. Place kettle into power base. Turn the switch ON by
pressing down on ON/OFF switch. ON/OFF light will turn on indicating
kettle is ON. Let the water boil.
3.
When the water and unit have cooled, discard the water. Rinse with cold water
and repeat.
4.Your electric kettle is now ready for use.
U
SING
Y
OUR
E
LECTRIC
K
ETTLE
1. Position the power base on a flat heat-resistant surface as close as possible
to a wall socket.
(For cordless model only)
2. Shorten the power cord by winding excess power cord into the cord storage
area underneath the power base. Push the power cord fully into the cord
exit in the power base.
(For cordless model only)
3. Ensure the switch is in the “OFF” position (press the rear of the switch).
4. Remove the kettle from its power base.
(For cordless model only)
5. Open the lid and fill the kettle via the lid opening. The lid will open only
to about 90°, do not try to force it past this point, otherwise you will
damage it.
6. Fill the electric kettle with water between the “MIN” and “MAX” water
level mark. NOTE: Do not fill with less than the “MIN” water level mark
indicated on the electric kettle Also, do not exceed the “MAX” water level
mark indicated on the electric kettle. Close the lid before switching on,
otherwise the kettle may not switch off when it boils.
7. Do not overfill the kettle. If the kettle is overfilled, there is a risk that
boiling water may be ejected.
8. Plug the power base into the wall socket. Gently position the kettle on
the power base, taking care not to spill any water.
(For cordless model only)
9.
For the model with cord, plug the cord into the wall socket.
10. Press the front of the switch. The “POWER-ON” light will illuminate
and the kettle will start to heat up.