Sunbeam SK4200P Fryer User Manual


 
Heading
17
Care and Cleaning
Always turn the power off and remove the
plug from the power outlet after use and
before cleaning. Allow appliance to cool
before cleaning.
Control probe
If cleaning is necessary, wipe over with a
damp cloth.
Note: The control probe must be removed
before the frypan or skillet is cleaned and the
control probe inlet must be dried before the
frypan or skillet is used again.
Important: Do not immerse the control probe in
water or any other liquid.
Store the control probe carefully. Do not
knock or drop it as this can damage the
probe. If damage is suspected, return the
control probe to your nearest Sunbeam
Appointed Service Centre for inspection.
High domed metal lid
(Models: FP5500P, FP5610P, FP5900P, SK4200P)
Wash the lid in warm soapy water using a
soft sponge, rinse and dry thoroughly. Metal
scourers will scratch the surface and should
be avoided. Some food such as tomato paste
and curry may stain the surface. This staining
may be removed or reduced by rubbing with
a cream cleanser or a paste of bicarbonate of
soda and water.
Note: Do not place metal lid in a dishwasher.
Glass lid (FP5910)
Wash the lid in warm soapy water using
a soft sponge, rinse and dry thoroughly.
Alternatively, wash the lid in a dishwasher.
To clean interior and exterior surface
When cleaning the Teflon Platinum Pro
non-stick coating do not use metal (or
other abrasive) scourers. After cleaning, dry
the frypan/skillet and lid with a soft cloth
before storing.
Wash the pan and base in hot soapy water
or in a dishwasher. Remove stubborn spots
with a plastic washing pad or sponge.
The heating element is totally sealed,
making the frypan or skillet safe to fully
immerse in water, or place in a dishwasher.