Sunbeam SM6100 Mixer User Manual


 
Important: Your StickMaster should be rinsed
thoroughly after each use.
After each use
1. Always remove the power cord from the
power outlet before cleaning and remove the
detachable shaft of the StickMaster.
Note: Do not immerse the detachable shaft of
the StickMaster in water because overtime the
lubrication on the bearings will wash away.
2. Wash the detachable shaft under running
water, without the use of abrasive
detergents.
3. When you have finished cleaning the
detachable shaft of the StickMaster, place it
upright so that any water which may have
got in, can drain out.
4. Attachments including the beaker, chopper
bowl, chopper lid and chopping blade
(chopper provided with models SM6210 and
SM8310) and whisk (provided with model
SM8310) can be washed in hot soapy water.
5. Dry thoroughly.
Important: Blades are extremely sharp, handle
with care.
For a quick wash up
Between processing tasks, hold the StickMaster
in the beaker half filled with water and turn on
for a few seconds.
Dishwasher Use
All plastic components deteriorate through the
prolonged use of a dishwasher for cleaning.
However, parts of your StickMaster are tolerant
to dishwasher use. These include the beaker,
chopper bowl, chopping blade (chopper
provided with models SM6210 and SM8310)
and whisk (provided with model SM8310).
Note: Place only on the top rack of your
dishwasher.
Note: The detachable shaft and chopper lid are
not dishwasher safe. Wipe down with soapy
water.
Motor Housing
Clean down the motor housing with just a damp
cloth.
Important: Ensure that the motor housing is not
immersed in water or any other liquid.
9
Care and Cleaning.
Sunbeam is a registered trademark. StickMaster is a
trademark of the Sunbeam Corporation. Made in Slovenia.
Due to minor changes in design or otherwise, the product
may differ from the one shown in this leaflet. Approved by
the appropriate Electrical Regulatory Authorities. Backed
by Sunbeam‘s 12 Month Replacement Guarantee and
National Service Network.
© Copyright. SUNBEAM CORPORATION LIMITED 2001.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
For more information or advice on any Sunbeam products,
contact the Sunbeam Consumer Service Line on 1800 025 059
in Australia. In New Zealand - contact the Sunbeam Office in
Auckland on 09 912 0747.