Filter
Top Products
Using the shot of steam
The shot of steam can be used whether dry
or steam ironing when the temperature dial
is set to any temperature above the two dot
(••) setting.
1. Ensure the tank is at least ¼ full of
water.
2. Select the desired temperature and wait
until the thermostat light goes out.
3. Press the shot of steam button several
times with the iron on the soleplate to
prime the pump.
NOTE: If the tank has run dry, it may be
necessary to re-prime the pump after filling
the iron with water.
Using the spray mist
The spray mist can be used whether dry
or steam ironing to pre-dampen hard to
iron fabrics.
1. Ensure the tank is at least ¼ full of
water.
2. Press the spray button during ironing
to release a fine mist from the spray
nozzle.
Using your Sunbeam Pro Steam Iron (continued)
7
The safety auto-off mechanism automatically
turns the iron off if you forget.
The iron will automatically shut off if left
on the heel rest (vertical) for 15 minutes,
or in the ironing position (horizontal) for 30
seconds, without being moved.
The thermostat light on the handle will flash
and a warning beep will sound to let you
know that you have left the iron unattended.
Power to the iron's heating element will be
cut.
Once the iron is moved the power will
reconnect. Allow the iron to heat until the
thermostat light goes out, and continue
ironing as normal.
The safety auto-off feature
(Model SR4300 only)
15 minutes 30 seconds