Filter
Top Products
Dry ironing
Followsteps1and2above.
3.SelectDRYonthesteamdial.
This will cut off the steam flow if there
is water in the tank.
Using the shot of steam
The shot of steam can be used when dry
or steam ironing, when the temperature dial
is set to any temperature within the steam
bandorabovethetwodot(••)setting.
1.Ensurethetankisatleast1/4fullof
water.
2. Select the desired temperature and wait
until the thermostat light goes out.
3.Presstheshotofsteambuttonseveral
times with the iron on the soleplate to
prime the pump.
NOTE: If the tank has run dry, it may be
necessary to re-prime the pump after filling
the iron with water.
Using the spray mist
The spray mist can be used whether dry or
steam ironing to pre-dampen hard to iron
fabrics.
1.Ensurethetankisatleast1/4fullof
water.
2. Press the spray button during ironing to
release a fine mist from the spray nozzle.
The safety auto-off mechanism automatically
turns the iron off if you forget.
The iron will automatically shut off if left
on the heel rest (vertical) for 15 minutes,
orintheironingposition(horizontal)for30
seconds, without being moved.(See figure 2).
The thermostat and power lights on the
handle will flash to let you know that you
have left the iron unattended.
Power to the iron's heating element will be
cut.
Once the iron is moved the power will
reconnect. Allow the iron to heat until the
thermostat light goes out, and continue
ironing as normal.
7
Using your Sunbeam Verve Iron (continued)
The safety auto-off feature
Figure 2
15 minutes 30seconds