Sunbeam SR6585 Waffle Iron User Manual


  Open as PDF
of 12
 
Before first use
Remove any adhesive stickers, plastic covers
or cardboard sleeves from the soleplate.
Ensurethatalladhesiveisremovedby
rubbing the soleplate with a cloth
dampened with methylated spirits.
Fillthewatertankandemptythewater.This
will rinse out any foreign particles remaining
in the water tank from the manufacturing
process.
NOTE: When turned on for the first time,
your new iron may give off vapours for up
to10minutes.Thisisduetotheinitial
heating of the materials used. It is safe, not
detrimental to the performance of the iron,
and will not reoccur.
Filling the iron with water
Before filling the iron with water ensure the
power is turned off and the plug is removed
from the power outlet. The iron can be filled
with water while it is hot.
Place the iron on its heel and open the water
inlet cover.
Slowly pour water into the water inlet until
themaximumwaterlevelisreached.Donot
exceedthemaximumwaterlevelindicator.
Push the water inlet cover firmly to close.
NOTE: The special soleplate design allows you
to use tap water with your Verve iron without
affecting the steam performance. However in
very hard water areas, Sunbeam recommends
the use of distilled water, or water which has
been demineralised.
Forbestperformance,werecommend
theuseofSunbeamWaterDemineraliser,
available from selected retailers. This will
produceupto30litresofdemineralised
water.
Donotfilltheironwithfabricconditioner,
starches or any other solution as these will
damagethesteammechanism.Donotuse
contaminated water.
Using your iron
1.Inserttheplugintoa230/240voltpower
outlet and turn the power on. The power
ONlight(positionedontopofthehandle)
will illuminate to indicate that the iron is
switched on and heating.
2. Turn the temperature dial to the desired
setting by aligning the setting on the
dial with the temperature indicator. The
thermostat light will illuminate to indicate
that the iron is heating to the selected
temperature. When the thermostat light
goes out the iron has reached the selected
temperature and is ready to use.
NOTE: When the temperature dial is changed
from a high setting to a lower temperature
setting during ironing, the thermostat light
will go out immediately. This indicates
that the iron is cooling to the selected
temperature. To ensure that the iron has
reached the selected temperature and is not
too hot, wait until the thermostat light comes
on again and then goes out before ironing.
Steam ironing
Followsteps1and2above.
NOTE: When steam ironing, ensure that the
temperature dial is set to any temperature
within the steam band, and that the tank is
atleast1/4fullofwater.
3.Turn the steam dial to the desired steam
setting.
Forbestresults,selectthesteamsettingthat
corresponds to the selected temperature, as
indicated on the temperature dial.
6
Using your Sunbeam Verve Iron
Steam
Temperature
 previous next