Filter
Top Products
9
Filtering chilled water.
• Use either the manual water dispenser button
or the continuous flow button. The unit will
dispense up to 1.1 litres of chilled water
at a time. If the entire 1.1 litres of water is
dispensed, the unit will require time to chill the
water again. The ready light will indicate that
the unit is able to dispense chilled water.
• After fitting a new filter always flush out the
filter before use.
• To do this, simply filter one full tank.
• The appliance should be left overnight to chill
after flushing.
Filter life.
• The life of your filter will be affected by the
quality of your tap water. When you notice that
the water begins to flow very slowly from the
spout it is time to change the filter. This can
be any time from one month to six months
depending on the area where you live.
However, it must be replaced at least every
six months. The label on the filter will help you
to remember when this is. In addition to the
Super Fine Filter supplied with the appliance,
a longer lasting General Purpose Filter is also
available and is ideal to use in areas where
the mineral content of the water is high.
However, this filter will not remove giardia or
cryptosporidium.
Replacing the filter.
Removing the filter
• Switch off and unplug the appliance.
• Remove the water tank.
• Remove and discard the old filter.
• If black O-ring seals remains inside the
appliance remove and discard them.
Installing the new filter
• Remove the two clear plugs from the new
filter
• Wet the new O-ring seals and snap the filter
into place.
• Place a tank of water on the base and plug
the appliance into the power outlet.
• Flush the filter as explained above.
If the appliance has not been used for more
than two weeks, flush the filter before use.
Using your Water Filter and Chiller (continued)